MFT height

[surreyjoineryuk]

Hi guys,

Looking to get the MFT (the large one!) but I think its taller than the smaller ones (for the kapex), if this is true then can I still join the 2 together? I have seen in a youtube vid they sell joining rods but if they are different heights how can they join?
many thanks
Jamie

 

[copcarcollector]

The MFT/3 and the MFT Kapex can not be joined together with the MFT connectors, 2 different heights

 

[GarryMartin]

The MFT/3 has a working height of 900mm and the MFT KAPEX 790mm, so as noted above and as you surmised, you can't connect them together.

 

[surreyjoineryuk]

In this vid they join them together, am I being a dumbo?

 

[GarryMartin]

That's not a MFT KAPEX in the video, it's two MFT/3 tables, one turned at 90 degrees to the other.

 

[bertv]

There is a reason for this *madness*: the height of an MFT/3 is equal to the outfeed of the MFT/Kapex (900 mm = 790+110 mm).

But that being said there should have been a way to interconnect them.

 

[Bohdan]

There is a reason for this *madness*: the height of an MFT/3 is equal to the outfeed of the MFT/Kapex (900 mm = 790+110 mm).

But that being said there should have been a way to interconnect them.

Yes there is. Put the lower one on 110mm blocks.

 

[Corwin]

There is a reason for this *madness*: the height of an MFT/3 is equal to the outfeed of the MFT/Kapex (900 mm = 790+110 mm).

But that being said there should have been a way to interconnect them.

Yes there is. Put the lower one on 110mm blocks.

Uhm, I know you really meant to say to put it on 4 Systainer 1's, didn't you?  [blink] [wink]

You know, one pulling each leg.  [smile]