MFT

[paul_david_thomas]

Nooooo.... Don't say you've worked their ?

Yes, Rijswijk !! I used to drive in from where I was staying - where ever that might have been.

This was some 20 years ago however, working on the OS/2 Servers they had in the computer department. They must be Windoze or Linux now.

Do they still have the naked pool parties ? Or have times changed at the Patents office ... If you don't work their, that will certainly give you an incentive to go for an interview !

I have to say, anyone looking into this thread is REALLY going to think we have gone off subject

I had some very funny times. Actually, I think it might be a bit more than 20 years. I'm 43 and I remember getting the ferry back on my 21st birthday.

 

[jo041326]

Hi,
I think you will quickly realise you need two MFTs. I went the same way. Bought TS55 with MFT and later added the second one. Unlike others here I had still some squarness problems. Tuned up the rail and after some time it was slightly off. I had to check the squarness before every batch of cutting. At the end I was so tired I have bought Hammer B3 Winner Comfort saw. Man! Why was I so fool and didn't spend the money into Hammer instead of all that MFT stuff!
If I will be in your position with my current experience I'd buy some Hammer saw (for the stuff you mentioned probably Hammer B3 winner).
Josef

 

[mattfc]

Nooooo.... Don't say you've worked their ?

Yes, Rijswijk !! I used to drive in from where I was staying - where ever that might have been.

I have worked in the data centre in the basement back in 1999 (a large oil company used to use it), and frequently still go past it, although I have never seen any naked pool parties there, that said my dutch collegues are pretty liberal

 

[cje]

MTFYH

MTFYH ???

Even www.acronymfinder.com doesn't know that one...

 

[paul_david_thomas]

Matfc,

Would that have been to the Shell offices ? Been drunk in that place too !! Did they not have a cracking bar on the top floor or something ?