I know we all love our MFT tables...I unfortunately only have the MFT 1080...but have read of the newer capabilities of the MFT3 and really like it...more than likely will have to have one.
I have also been eyeballing the new Klamp table from Kreg. What do you guys think about that table? Before I lay down 400.00 on that table....and without having seen the MFT3 yet...can all the same functionality of the Klamp table be had with the MFT3? I know WAY more can be done with the MFT3 but specifically can all of what is capable of the Klamp table be handled with the MFT3?
If so, how would you do it? Also, can the clamps be used on the MFT3 or would you use Festool clamping to do the same job?
I am thinking that the clamping element stops could be used to slide face frame components square to each other to then use pocket hole screws for the assembly....what I haven't figured out is how to clamp them in place before I take the cordless to the face frame parts...
What do you guys think?
Barry
I have also been eyeballing the new Klamp table from Kreg. What do you guys think about that table? Before I lay down 400.00 on that table....and without having seen the MFT3 yet...can all the same functionality of the Klamp table be had with the MFT3? I know WAY more can be done with the MFT3 but specifically can all of what is capable of the Klamp table be handled with the MFT3?
If so, how would you do it? Also, can the clamps be used on the MFT3 or would you use Festool clamping to do the same job?
I am thinking that the clamping element stops could be used to slide face frame components square to each other to then use pocket hole screws for the assembly....what I haven't figured out is how to clamp them in place before I take the cordless to the face frame parts...
What do you guys think?
Barry