mft3 leg positions

[rnt80]

I bought both of my mft3 tables used and never went through the process of assembling them. I noticed tonight that one of the sets of legs is bolted to the table through the outside hole and the other set is bolted through the inside hole.  I also just realized that those holes are at slightly different heights. Are both sets of legs supposed to be bolted to the table through the holes that are in the same position?

 

[Administrator_JSVN]

One set of legs should be attached through the left hole, one set through the right. If you're able to fold them into the collapsed position, then you should be good.

[attachimg=#1]

 

[rnt80]

Thanks, Shane.  Now I just need to figure out how to fix the adjustable leg that doesn't adjust.  Is that a piece I can get from the service department?

 

[Administrator_JSVN]

Yes, just give service a buzz and they'll fix you right up.

 

[semenza]

This thread might be helpful too http://festoolownersgroup.com/festool-jigs-tool-enhancements/adding-a-second-adjustable-foot-to-mft/

Part #s are in this thread too .

Seth

 

[tiralie]

Thanks, Shane.  Now I just need to figure out how to fix the adjustable leg that doesn't adjust.  Is that a piece I can get from the service department?

Russ:
I like everything to work properly, so I replaced my adjustable foot after I broke it by forcing the cam and , but in reality there really isn't enough travel in the cam mechanism to make it worthwhile.
You can look up the parts you need for your adjustable leg on the Ekat (sp)
Tim