MarkoSharko
Member
- Joined
- Oct 23, 2014
- Messages
- 12
Hi,
I designed a moxon vise specifically for the MFT/3. The vise uses table connector hardware so the back (fixed) jaw can be slipped on or off quickly. You can go to the URL below has both the instructions and the SketchUp file used in construction of the vise.
http://www.seasholes.com/Projects_Plans_Page.html
Attached here are just the instructions and two photos (that can also be found in the PDF). Hope people can find this useful.
I designed a moxon vise specifically for the MFT/3. The vise uses table connector hardware so the back (fixed) jaw can be slipped on or off quickly. You can go to the URL below has both the instructions and the SketchUp file used in construction of the vise.
http://www.seasholes.com/Projects_Plans_Page.html
Attached here are just the instructions and two photos (that can also be found in the PDF). Hope people can find this useful.