- Joined
- Feb 8, 2007
- Messages
- 1,671
this was from a refferel in the same neighborhood from my last project. I used a 1/4" fluting bit in my 1400 router and did 5 rows of flutes on a 3" board spaced 1/2" apart and an 1 1/2" spacing at top and bottom to make the design.
since I bought another mft 3 and use 2 ot the job site when I make these units,, it makes so sweet to work on longer boards for cutting, rouiting etc.
again all of these is custom made from scratch using birch ply and clear pine.
I use almost all of my festools in making these projects especially my ts55 saw and guide rails, including the 105" one. In case you do not have this saw now would be agood time to buy one as they are on sale for 10% OFF a great deal for this magnificant tool !
also they did not want the tv on the wall so i bought one of those pull out swivil stands and added a board to it so they can pull out and turn the tv.
since I bought another mft 3 and use 2 ot the job site when I make these units,, it makes so sweet to work on longer boards for cutting, rouiting etc.
again all of these is custom made from scratch using birch ply and clear pine.
I use almost all of my festools in making these projects especially my ts55 saw and guide rails, including the 105" one. In case you do not have this saw now would be agood time to buy one as they are on sale for 10% OFF a great deal for this magnificant tool !
also they did not want the tv on the wall so i bought one of those pull out swivil stands and added a board to it so they can pull out and turn the tv.
