New Stairway Overhaul (before & after)

[Sparktrician]

Thanks again.  Now to get my lock miter bit setup

For anyone wanting to use the lock miter bit, you might want to check out Infinity Tool's LMM-002 Lock Miter Master Jig for aligning the bit to the fence and to the workpiece.  It's also mentioned in an article in Fine Homebuilding.  There's also a good video on setting up the bit.  It won't eliminate fine tuning, but it will save a ton of time setting up the bit.  YMMV...

 

[WoodWhisperer]

Thanks again.  Now to get my lock miter bit setup

For anyone wanting to use the lock miter bit, you might want to check out Infinity Tool's LMM-002 Lock Miter Master Jig for aligning the bit to the fence and to the workpiece.  It's also mentioned in an article in Fine Homebuilding.  There's also a good video on setting up the bit.  It won't eliminate fine tuning, but it will save a ton of time setting up the bit.  YMMV...

That would help a lot I'm sure!!
I still have mine set up and I'm not taking it out of my router table till I have to!!

 

[butzla]

Nice work on the posts!  I'm a huge proponent of the lock miter bit.  I use it on all my kitchen cabinet/vanity drawers.  You don't need to plunk down any hard-earned on fancy gauges.  I did a tutorial on a drawer build on sawmill creek using 2 pieces of scrap it's on post #3:  Lock Miter Tutorial and our own Peter Parfitt made a rather excellend Youtube showing the setup in more depth.

 

[Jeffonebuck]

Nice work Sean, a lot of work went in to this and you put your Mark on it.