Bought some new cordless tools recently, and as nice as the bag is that came with them, I decided to store them in Systainers. I have templates for T-locs and classics, so used 12mm ply for the bases and divisions. Marine/outdoor carpet was then contacted to the bases. The circ saw has a build up which forms a slot for the blade guard, and the two dowels fit into holes that are in the saw base. (Classic sys 4)
Impact driver is in an attic sys 2
Rotary hammer in a sys 2 T-loc.
Edge lipping planer is in an attic sys3. Would have preferred a standard T-loc, but none in stock. The height is tight in this one, so I cut the base out, to take the planer - it just fits.
Still need to do one for a Hilti 125mm cordless grinder and accessories.
Impact driver is in an attic sys 2
Rotary hammer in a sys 2 T-loc.
Edge lipping planer is in an attic sys3. Would have preferred a standard T-loc, but none in stock. The height is tight in this one, so I cut the base out, to take the planer - it just fits.
Still need to do one for a Hilti 125mm cordless grinder and accessories.
