- Joined
- Nov 21, 2015
- Messages
- 850
I'm just arting with a TS-55-REQ and rails. This thread is extremeley interesting although hard to understand because it makes reference to things, suppliers and methods you all know. Too bad I have not seen an of this demonstrated on you tube. The Precision website leaves a lot to the imagination from a learning standpoint.
I am looking for a basis to decide what to do for ripping an cross cutting.
adhesive tape rulers:
if you want to apply any adhesive backed material and place it accurately, you can use a spraybottle with water and a bit of dishsoap to relieve surface tension. Spray it on the equipment and the PSA backed material can be "floated" into position until you use a suitably sized squeegee to squegee the water out - bingo - done . Hope this helps pay back the help I'm getting from all the FOG postings.
Hans
I am looking for a basis to decide what to do for ripping an cross cutting.
adhesive tape rulers:
if you want to apply any adhesive backed material and place it accurately, you can use a spraybottle with water and a bit of dishsoap to relieve surface tension. Spray it on the equipment and the PSA backed material can be "floated" into position until you use a suitably sized squeegee to squegee the water out - bingo - done . Hope this helps pay back the help I'm getting from all the FOG postings.
Hans