What is the proper way to store the Kapex for transport on the UG stand? I understand to swing the miter all the way to the right, but should the saw be pulled all the way to the front of the rail, or nested all the way in the rear? Should the bevel angle be set to 0*, or is it better to set it to another angle?
Proper way to store Kapex?
- Thread starter gbruzze1
- Start date
- Joined
- Jan 22, 2007
- Messages
- 8,426
Head at 60 degrees to the right, all the way back, locked down in the transport position. Turn the knob that prevents rail travel. Bevel @ 0.
[attachimg=#1]
[attachimg=#1]
