Removing old adhesive from the track guide splinter guard

[jpclifton]

I have a festool track saw and need to replace the guide rail plastic splinter guard.  What is the best way to remove the old adhesive without damaging the track?

Thank you.
Jeff

 

[kostello]

Razor blade...

 

[jpclifton]

Will acetone remove the residue?

 

[Administrator_JSVN]

As mentioned, a razor blade or scrapper will do the trick. You can use acetone to clean any residual adhesive off.

 

[AlexThePalex]

No scraping needed, just use a cloth with paint thinner or white spirit to dissolve the residu.

 

[#Tee]

i peeled mine right off moved it over 2mm and reused it. worked like new cause previously i used it to rip a 45 degree.

 

[rst]

If you use a razor blade, round the outside edges first.  This will prevent the blade from digging into your rail.  Acetone or lacquer thinner will cut the adhesive quickest.

 

[rst]

I usually use the cut edge of a piece of acrylic as a scraper, less chance of scratching anything.

 

[mouppe]

I use a chisel to get most of the glue off, then denatured alcohol.