Replacing Kapex fence that is not flat

fshanno

Member
Joined
Sep 20, 2007
Messages
1,064
I have one of the fences that's not flat and I get some burning and cuts that aren't quite dead square when the workpiece that rests against both halves of the fence.  Up till now I've just kept it adjusted so that the left hand side is perpendicular to the blade.  So when I need dead flat I make sure my piece is only resting on the left and doesn't span the gap.  But I'm tired of it now.

Can I order a replacement fence body?  I think it is part no. 470620.  Interestingly it's called a "stop".

And if I can order it will you check it before shipping to make sure it is flat?
 
I would suggest that you call the service department and talk to them.  You might be surprised.

Peter
 
Back
Top