I have had a TS75 EQ and love it. However, the riving knife is no longer aligned with the blade. When I cut it holds back and then springs into the gap. Not good. I can't find anywhere to adjust it. I have taken the knife completely out, cleaned it, adjusted it closer to the blade per the 2-4 mm spec but it still wiggles left and right. I don't think it should do that. Any thoughts?
Riving knife not aligned on TS75
- Thread starter RonMiller
- Start date
Crazyraceguy
Member
- Joined
- Oct 16, 2015
- Messages
- 4,897
How old is it? Warranty? if so, maybe send it in to be checked out
Crazyraceguy
Member
- Joined
- Oct 16, 2015
- Messages
- 4,897
If you live in a big enough area, there might be a dealer that does repairs on-site? This "may" be preferrable to the cost of sending it away.
Your info says "Western KY" which is not very specific, which is fine, I get it. But if you are close enough, there is a place in Cincinnati called Edward B Mueller Co. They can probably fix you up.
Your info says "Western KY" which is not very specific, which is fine, I get it. But if you are close enough, there is a place in Cincinnati called Edward B Mueller Co. They can probably fix you up.
