Router Table Laser

[Birdhunter]

In cutting stopped dados and other cuts on my router table, I often wish I had a sharply focused laser lines that crisply delineated where the front and back of the bit were. I have that feature on my Kapex. I could see the two lasers on goosenecks attached to my router fence providing the lines.

Does anyone make such a tool?

 

[Bob D.]

In place of mounting on gooseneck arms what about embedded in the table top.

 

[DynaGlide]

In cutting stopped dados and other cuts on my router table, I often wish I had a sharply focused laser lines that crisply delineated where the front and back of the bit were. I have that feature on my Kapex. I could see the two lasers on goosenecks attached to my router fence providing the lines.

Does anyone make such a tool?

[member=15289]Birdhunter[/member] Perhaps a different angle to attack this problem:

Skip to the 5:44 mark.