clutzer
Member
- Joined
- Dec 24, 2014
- Messages
- 37
Hello everyone, brand new member here and to the festool community all together.
I did some light searching of this forum for threads on mounting a router plate into the MFT (I have the MFT/3). There doesn't seem to be anything readily popping up. So, I threw together a quick concept of what I'd like to do in SketchUp (image attached). Is there anything that immediately jumps out at people?
Note 1: I'm simultaneously considering the plate on the opposite side of the table from the track-saw rail so it doesn't interfere with the router--the caveat is that the Incra fence would have to be removed to do cross cuts as opposed to just lowering the router bit.
Note 2: The kerf line might be a little close to the miter rail, but I haven't dimensioned this out on my table yet--this is just a rough concept I'd like to get opinions on--mostly why this doesn't seem to be a popular mod for the MFT/3.
I did some light searching of this forum for threads on mounting a router plate into the MFT (I have the MFT/3). There doesn't seem to be anything readily popping up. So, I threw together a quick concept of what I'd like to do in SketchUp (image attached). Is there anything that immediately jumps out at people?
Note 1: I'm simultaneously considering the plate on the opposite side of the table from the track-saw rail so it doesn't interfere with the router--the caveat is that the Incra fence would have to be removed to do cross cuts as opposed to just lowering the router bit.
Note 2: The kerf line might be a little close to the miter rail, but I haven't dimensioned this out on my table yet--this is just a rough concept I'd like to get opinions on--mostly why this doesn't seem to be a popular mod for the MFT/3.