Woodwork Wizard
Member
- Joined
- Oct 25, 2013
- Messages
- 431
Using the 5 cut method to establish what the error is on the off-cut I had to move my MFT guide rail approximately 0.11mm - so I had the idea of using a second locking stop with a set of feeler gauges between them to set this gap. Now the error is so insignificant I think I'd just end up sending myself completely mental trying to make it any less.
No idea if it is called a locking stop so here's a photo of what I did.
No idea if it is called a locking stop so here's a photo of what I did.