R RonMiller Member Joined Oct 17, 2009 Messages 382 Oct 22, 2009 #1 I can't find the size (depth?) of the router aid. I'm wondering when it's put on a board edge, how deep does the board have to be to hold up the aid? If the board is too shallow, any suggestions, of how to use it?
I can't find the size (depth?) of the router aid. I'm wondering when it's put on a board edge, how deep does the board have to be to hold up the aid? If the board is too shallow, any suggestions, of how to use it?
A Administrator_JSVN Guest Oct 22, 2009 #2 The depth, if I assume what you mean by depth correctly, is about 3-1/8". Ideally your material should be at least this thick.
The depth, if I assume what you mean by depth correctly, is about 3-1/8". Ideally your material should be at least this thick.
J johnsonri Member Joined Aug 5, 2007 Messages 390 Oct 22, 2009 #3 Shane Holland said: The depth, if I assume what you mean by depth correctly, is about 3-1/8"... Click to expand... [off topic] I didn't know that Festool employees spoke imperial. [big grin]
Shane Holland said: The depth, if I assume what you mean by depth correctly, is about 3-1/8"... Click to expand... [off topic] I didn't know that Festool employees spoke imperial. [big grin]
R RonMiller Member Joined Oct 17, 2009 Messages 382 Oct 22, 2009 #5 That's what I was looking for. Thanks!
J jeffinsgf Retailer Member Joined Oct 23, 2009 Messages 1,174 Location Northeast Ohio Oct 24, 2009 #6 Rey Johnson said: Shane Holland said: The depth, if I assume what you mean by depth correctly, is about 3-1/8"... Click to expand... [off topic] I didn't know that Festool employees spoke imperial. [big grin] Click to expand... He's bilingual. [big grin]
Rey Johnson said: Shane Holland said: The depth, if I assume what you mean by depth correctly, is about 3-1/8"... Click to expand... [off topic] I didn't know that Festool employees spoke imperial. [big grin] Click to expand... He's bilingual. [big grin]
