So took the plunge and bought myself a CMS base along with the OF module and the y section hose with the correct adapter for it to go onto my CT Midi.
Been using it a bit today for a few test and calibration cuts and whilst i am happy with how it performs the cuts i am almost appaled at the dust collection!!
I have my midi turned up to full power and have checked the bag and whilst over half full it should still be fine, i even gave the bag outer a few blasts of compressed air to make sure the pores in the bag were not clogged.
The picture attached is what i found when i removed the fence and this is does not include all the dust i had already hovered off the table itself before removing the fence. And this was after maybe a dozen or so test passes. The ring insert was correct for the bit used and the fence spacing was up close to the it as it should be.
I was under the impression the Midi had the same suction power as the bigger CT26 etc so short of trying a new bag which i don't think i should given its not full i am at a loss.
Been using it a bit today for a few test and calibration cuts and whilst i am happy with how it performs the cuts i am almost appaled at the dust collection!!
I have my midi turned up to full power and have checked the bag and whilst over half full it should still be fine, i even gave the bag outer a few blasts of compressed air to make sure the pores in the bag were not clogged.
The picture attached is what i found when i removed the fence and this is does not include all the dust i had already hovered off the table itself before removing the fence. And this was after maybe a dozen or so test passes. The ring insert was correct for the bit used and the fence spacing was up close to the it as it should be.
I was under the impression the Midi had the same suction power as the bigger CT26 etc so short of trying a new bag which i don't think i should given its not full i am at a loss.