STM1800

[Boski]

I'm thinking of getting one, but understand the wheels need changing.

Does anyone know the specs? I have found these that look really good for the money, and wondered if they could be used.
https://www.amazon.co.uk/KOSTANZO-L...&hvtargid=pla-2281435176858&gad_source=1&th=1

 

[peter halle]

Why do you feel the wheels need changing?

Peter

 

[woodferret]

I've only heard of people swapping out the two non-locking ones with the lockers... via ekat.

 

[Fourmi]

I changed out my set of wheels for a set of all black silent roll 4x locking wheels - but you can use it without doing this, you do not at all 'need' to change out the wheels.

The wheels you link to are not right though, from memory you need a 10mm hole in the base of the wheel mount. Also 300kg load rating is excessive, the table is not made for supporting and wheeling around this kind of weight.

If it is important for you to have the same height as the MFT and other Festool work surfaces, you need to pay attention to the overall height of the wheel, and if this is the case, it is probably easier just to order the two locking wheel mounts from Festool.

 

[twistsol1]

The wheels are 100mm stem casters with an M10 1.5 threaded post. I bought the wheels shown below when I broke one in an ice rut in -30F weather. I did order a replacement and go back to the originals because even though they aren't quite as durable, they weigh far less.
https://www.amazon.com/gp/product/B09D4TWYDX/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1