Syslite charger without plug

bigGaloot

Member
Joined
Jan 18, 2013
Messages
25
Had the afternoon off, wanted to check out the new sys-roll, and knew I was going to get a toolbox.  The weather was great and figured I would drive down to Woodcraft to do some shopping.  I ended up justifying a Syslite as well and upon arrival back at my place, it appears that it is missing a crucial component.  There is a a lamp, a car charger, and what is intended to be a wall charger, but there is no plug with which to plug it into an outlet.

[attachthumb=1]

[attachthumb=2]

My question to the forum:  Do I return the KAL to Woodcraft to get a properly stocked unit, or should I go through Festool USA for the missing piece?
 
As mentioned you need to clip the plug in.  Check the bag to see if it's hiding in there.  If not you can go either route to get this sorted.  Woodcraft will get you taken care faster, assuming they have another light in stock. 
 
I just checked again, very thoroughly.  It is definitely not there.  I guess I'll make another trip down to Woodcraft... and I'll probably end up buying that c15 I was playing with today.  Curse you festool.
 
bigGaloot said:
I just checked again, very thoroughly.  It is definitely not there.  I guess I'll make another trip down to Woodcraft... and I'll probably end up buying that c15 I was playing with today.  Curse you festool.

Well you know you need that C15 so that you have extra batteries for the Syslite.  ::) 

Seth
 
Worked all day today and didn't get a chance to do anything about the wall charger.  However, plugged it into the cigarette lighter last night and used it for a good four hours today before it kicked down to the low setting... at which point I went back to the bosch lights.  What a difference that LED array makes!

Also, it turns out that the auxiliary lighter in my van doesn't power off when the van is off.  Awesome for charging while still on site.
 
Back
Top