SysPort Capacity w/ Systainer 5

[Corwin]

I am considering the addition of a TS75 saw which comes in a Systainer 5 and cannot seem to find the chart for what size Systainers fit in a SysPort -- the one that includes the Systainer 5.  The Festool site seem to only show up through a Systainer 4.

???

 

[semenza]

Hi,

  I think you could use the chart for the systainer  IV , and reduce the rest of the configurarions by taking out a systainer - I.  Since the size difference between a  IV and a V is about the amount of a - I.
EX- On the chart it shows a  sys IV with five sys -Is. You should be able to fit a sys V with four sys - Is.  etc.

Seth

   

 

[Frank Pellow]

I have a systainer 5 in my Sysport.  As well as it, there are four systainer 1s in the sysport.

 

[Corwin]

Thank you!  That's what I thought, but really wanted to make sure.

 

[Forrest Anderson]

I am considering the addition of a TS75 saw which comes in a Systainer 5 and cannot seem to find the chart for what size Systainers fit in a SysPort -- the one that includes the Systainer 5.  The Festool site seem to only show up through a Systainer 4.

For some reason, the table in the US Festool catalogue doesn't list the Systainer 5, but the one on the UK catalogue does. Here are the two tables, and you'll see that there are 6 configurations which involve a Systainer 5. Note that the smaller Sysport 500, shown in the UK catalogue, is NAINA.

Forrest

 

[Corwin]

Now that's what I was looking for.  Thanks Forrest!  I knew I had seen that chart somewhere...