Ta 55 req

[Peter-kenny]

Hi guys is there anyway of adjusting the ts55 req  for the splinter guard on the rails
I had the old ts55 and I was able to do it with that but can't seem  to see it with this saw
Any info would be great
Cheers
Pete

 

[Ross 71]

Hi Pete,

There's two adjusters on the left hand side of the machine to make it sit snug on the rail. There isn't an adjuster(as far as I know, I might be wrong) for the blade. I understand that you adjust the strip to the saw by cutting it. When I messed up my splinter strip, I unstuck the strip, turned it round and re-stuck it with a decent overhang, then cut the strip as if it was new.

Hope this helps, Ross