Does anyone know of a template guide that fits the table widener baseplate. I am using a dish carving router bit and have a 30 mm template guide for it. The area I am routing is too wide for the standard baseplate. I just purchased the table widener baseplate and found it is thicker than the standard base and the template guide is recessed in the center. The guide sits below the table widener. The table widener has magnets for the detachable dust collector. I was wondering if there is a 30mm template guide that will fit where the magnets are. I can’t seem to find anything online. Does anyone know a solution?
Template guide for table widener baseplate on OF1400
- Thread starter drthorne
- Start date
Cheese
Member
You bring up an interesting point. [smile] It would make sense if Festool even made a simple adapter that would accept the typical Porter Cable style bushing. The adapter would then be held in place with the 3 magnets.
