Tool Curve - 3D printed dust adapters

[blues]

Hi, Has anyone bought these dust adapters from Tool Curve? Recently i placed an order for 4 dust port adapters. 2 out of the 4 work perfectly and other 2 the part numebrs were wrong and the incorrectly supplied part does not fit. I reached out with an email, explaining the problem. I think its a one man shop and he seems to be looking at email @ random. While i do want to encourage these small one man shops, it is frustrating as he does not check messages regularly. May be once a week @ best. He did acknowledge my email and asked for an explantion / pictures. I sent him both and also a small video clip explaining the incorrect fit. Its been over 2 weeks and i have not heard back. Its 2x25$ part, but its frustrating to do business with people who are less professional. Have any of you had any experiences dealing with Tool curve?

 

[tsmi243]

Black Raptor tools would be my recommendation.  Similar products, good support.

 

[Crazyraceguy]

I have. I bought a dust port adaptor for the compact Makita router. It fit properly and has worked well. I had no other interaction though, mine went ok the first time.

 

[gruz]

I also purchased two adaptors without incident. One for the RAS (which I see as correcting a bad tool design) and for a jobsite Dewalt table saw.
As mentioned, both fit and work as intended. Have no experience with their customer service but also assume it’s a one man operation.
Good luck!

 

[blues]

Thanks guys for your feedback. I have written to him again. No reply just yet. Hope all is well with him. Will wait (guess i don't have a choice) 

 

[Crazyraceguy]

Oh, I have the one for the TS55 also. I forgot about that yesterday. It is fantastic.

 

[krudawg]

Hi, Has anyone bought these dust adapters from Tool Curve? Recently i placed an order for 4 dust port adapters. 2 out of the 4 work perfectly and other 2 the part numebrs were wrong and the incorrectly supplied part does not fit. I reached out with an email, explaining the problem. I think its a one man shop and he seems to be looking at email @ random. While i do want to encourage these small one man shops, it is frustrating as he does not check messages regularly. May be once a week @ best. He did acknowledge my email and asked for an explantion / pictures. I sent him both and also a small video clip explaining the incorrect fit. Its been over 2 weeks and i have not heard back. Its 2x25$ part, but its frustrating to do business with people who are less professional. Have any of you had any experiences dealing with Tool curve?

Yes; bought an exhaust port  adapter to accept a 27mm Hose on an 8 1//2" Skilsaw Portable table saw - still using it; worked as advertised.

 

[Kevin Fester]

I have bought multiple times from tool curve . He is slow in response but reputable in my experience.

Ordered a arbor dust cover for my TS 75 on one of my orders .  He shipped the TS 55 one by mistake. Contacted him and it was a slow reply . However , he shipped out the correct one with now quibble.

My guess , he has a day job and family .