Hello Everyone, this is my first post on the forum.
i bought a Ts 55 and CT36 last December after reading about the Festool system. Before i got a chance to use it i got injured. It's been a long road to recovery but 11 months later I'm cleared to work and itching to build . So just this week i set my saw and 1400 rail up. My question is how long of a cut will the 1400 rail make accurately? I tried to cut some 3/4 inch Poplar that was 4 foot long and on each end i am off by a 1/16. Being new to Festool and track saw's i don't know if i set the saw up wrong or if i just need a longer rail? Any advice would be appreciated!!!!!
i bought a Ts 55 and CT36 last December after reading about the Festool system. Before i got a chance to use it i got injured. It's been a long road to recovery but 11 months later I'm cleared to work and itching to build . So just this week i set my saw and 1400 rail up. My question is how long of a cut will the 1400 rail make accurately? I tried to cut some 3/4 inch Poplar that was 4 foot long and on each end i am off by a 1/16. Being new to Festool and track saw's i don't know if i set the saw up wrong or if i just need a longer rail? Any advice would be appreciated!!!!!