TS 55 REQ PLUS adjustment

[seturner]

Hello,

I have read through posts addressing the issue of saw not cutting perpendicular to surface, but none I have read addressed the newer ts 55 with the two rear adjustment screws.  I know where they are, but do not know how to utilize them properly.

My relatively new saw is not cutting properly(gap in top when cutting workpiece and flipping Offcuts side over).

Can anybody assist?

 

[Frank-Jan]

Hi, welcome to the forum.
This thread shows the adjustment:https://festoolownersgroup.com/index.php?pretty;board=festool-how-to;topic=ts-55-req-setting-blade-angle-squareness.msg526970&topicseen#msg526970