I recently purchased the ferrous metal blade for my TS75 to cut some 24 gauge stainless sheet. After just one crosscut and one rip I noticed that two of the teeth had chipped off. Being that Festool says it can cut 1/8" stainless this does not seem right but in the warranty section it says blades are not covered. Is it possible to get a new blade or get a return for this one?
TS 75 Ferrous metal blade chipped teeth
- Thread starter NBK
- Start date
- Joined
- Jun 24, 2007
- Messages
- 10,361
Do you have blade 495383 or 495384?
Looking at the descriptions on the Festool USA site, the one is for Non-ferrous the other is for mild steel up to 1/8" (not stainless). Again I am just looking at the descriptions on the website, do you have additional info from some other source about them? Maybe on the packaging?
Seth
Looking at the descriptions on the Festool USA site, the one is for Non-ferrous the other is for mild steel up to 1/8" (not stainless). Again I am just looking at the descriptions on the website, do you have additional info from some other source about them? Maybe on the packaging?
Seth