TSO GRS 16 & GRS 16 PE??

[Bertotti]

Do you that use these find have two more accurate than having one and the smaller t shaped pice?

I have the GRS16PE and one of the smaller clips for my second piece and wondered if there are any gains in having two GRS instead of one. Thanks everyone!

 

[TSO_Products]

Hello Bertotti,
can you be a little more specific and describe what you mean by "small clips". Perhaps it easiest to post a snapshot of your set up and workpiece?

I'll respond more fully when I understand your sequence of cuts and the tools you use.

Hans

 

[Mike Goetzke]

Hello Bertotti,
can you be a little more specific and describe what you mean by "small clips". Perhaps it easiest to post a snapshot of your set up and workpiece?

I'll respond more fully when I understand your sequence of cuts and the tools you use.

Hans

My interpretation is he is asking is it more accurate to have two GRS's rather than one and a TPG adapter. I say once calibrated any combination including two TPG's is accurate as the others.

Mike

 

[krudawg]

I have both the GRS-16 and the FRS-16PE.  I found that using both on my long Makita Track (I have the TS-55 but purchased the Makita tracks because they  are cheaper) when taking down sheet goods gives gives me an additional check of square tracks.   

 

[sancho57]

I use 2 GRS when ripping long sheets. of ply.

along with 2 PGs and stops

 

[Bertotti]

Yes I meant the TPG. I rip long boards with the green on one end and the tpg at the other long being upwards of 10’-12’.