I remember that demo. I was just answering Andreas question if anyone had one.
Peter
Peter
VAC SYS
- Thread starter richard.selwyn
- Start date
EcoFurniture
Member
- Joined
- Sep 7, 2008
- Messages
- 608
Peter: Thanks for pointing those posts out! I should have read through the whole thing first [tongue]
MFG: Thanks for the info! That's exactly what I needed to know [big grin] Now I can call my family in Germany to place the order....
MFG: Thanks for the info! That's exactly what I needed to know [big grin] Now I can call my family in Germany to place the order....
PaulMarcel
Member
Wow, 8/4 oak... up until now, I wasn't paying much attention to this product since I assumed it would be mostly for smoother surfaces like smooth surface or a carving base that's prepared. Nice. Would be cool, too, if it could be used for smaller vacuum pressings.
richard.selwyn
Member
- Joined
- Jan 23, 2007
- Messages
- 635
What it really likes holding is melamine and similar products. With that you can even turn the pump off. Rough sawn wood can be held reasonably well, but it depends on your definition of rough sawn. Some plywoods seem more "porous" than others so don't get clamped down as hard. I use it for planed oak no problem - the more i use it the more I like it.
I am hoping to get a hand held edgebander which should really make the VacSys come into its own.
Richard
I am hoping to get a hand held edgebander which should really make the VacSys come into its own.
Richard
