32 inch Guide Rail???

[MrToolJunkie]

Hi everyone,

I am debating about adding a 32inch rail to my set when they go on sale next month -- I have a 55 inch and a 75 inch already (with a TS75) and I am thinking about getting the smaller size for cross-cutting solid lumber -- I currently use the 55 and it can be a bit unwieldy at times....so, would you opt for a 32 inch or would the next size up be a better option?  I do not have an MFT/3 and rely on cross-cuts with a speed square or the DeWalt T-Square only.  I am also interested in hearing feedback on Dr. Qwas's new square....and I guess another question is if this would fit a 32 inch rail for shorter cross-cuts....a may eventually break down and get the MFT/3....

Thanks!

 

[Brice Burrell]

Scot, I've got the 32" rail. It's not something I use everyday but it's really nice when I want it. The Qwas squares should be shipping out pretty soon I imagine, so feedback should be coming. I'm pretty sure it will work fine for short cross cuts in solid lumber with the 32" rail.

 

[Qwas]

We are expecting the Qwas Squares to ship any day now.

On the 32" rail, it will leave about 14 inch of cutting length. It's not a lot but if you make  a bunch small cuts it will be handy.  [smile]

 

[MrToolJunkie]

Thanks for the feedback....on the Qwas square, are these easily interchangeable between guiderails or is this something recommended to set up on a dedicated rail?  Is it easily calibrated to square?  I seem to recall reading on a previous post that you have to remove some of the rubber on the bottom of the rail.  I am anxiously waiting to hear all about the test runs once they are shipped. 

NVA_WW - I am in Southern California.

 

[Qwas]

It will be easy to interchange, 2 thumbscrews. Calibration is as simple as a push or a pull, no tools required and aligned as quick as you can tighten the thumbscrews.

Yes, you do need to remove 10-12 inches off of 1 rubber strip. It shouldn't be too big of a deal since this is where the saw resides before starting a cut so it wouldn't normally be holding the work piece here.

 

[TOOLMAN169]

I just purchased the 32 inch rail. It's great. I keep it in a festool's rail bag with 2 other 55 inch rail's