32mm copying ring for OF2200?

[RyanRoberts91]

does anyone have a product code for a festool of2200 32mm copying ring? I've searched on eBay but couldn't find any bigger than 30mm. It's for doing rough cut for an undermount sink in a mistral worktop, then I'll go over it again with 30mm ring. Are the of1400 and of2200 rings all the same or do both routers take a different copy ring? Thanks in advance.

 

[Wuffles]

Different from the 1400 I'm afraid.

My 2200 came with a 40mm I think if that's any use.

 

[Wuffles]

If you can figure out amending the template, this would do the job.

http://www.powertool-supplies.co.uk/festool-copying-ring-kr-d-40-0-of-2200.html

 

[RyanRoberts91]

Thanks wuffles. I would rather not alter the jig, I think 40mm will be too big as I plan to rout the sink out with 32mm then just trim the extra 2mm off with the 30mm for the finished cut. Just after I posted this, I found a 34mm ring. I may use this unless someone can point me in the direction of a 32mm?

 

[Wuffles]

Thanks wuffles. I would rather not alter the jig, I think 40mm will be too big as I plan to rout the sink out with 32mm then just trim the extra 2mm off with the 30mm for the finished cut. Just after I posted this, I found a 34mm ring. I may use this unless someone can point me in the direction of a 32mm?

Fair play, didn't realise there was a 34mm. Normally when I post about something not existing it's normally followed by a dozen posts stating it does with links, so my kiss of death might just help.

 

[AlexThePalex]

There is no 32 mm copying ring from Festool listed on their website. The 34,93 mm is the one that comes closest.

There is an adapter plate available that lets you use 3rd party guide bushings as described in this thread. Maybe you can find a 32 mm bushing that fits it.

 

[RyanRoberts91]

That's great. Thanks!