Thanks for posting this! When I created these I posted the link on some Facebook Festool group lists, but didn't know about this forum. If anyone is looking for the larger dominos for the DF-700, let me know via this thread and I'll add them to the group. Since I don't have the 700 I can't test the fit, but if someone is willing to test them for me, I'm good to create and add them.
OK. I'll model the 700 dominos and set up a print file. If someone wants to volunteer to do the test prints for fit, I can get them the files. I usually test on soft maple, both end grain and side grain. I should have something this afternoon. Volunteers?
12-100 and 14-100 prototype print file attached. If someone could test and let me know if the fit is good, that would be great. If it's too loose, using a feeler gauge to let me know the difference would be great. On the other hand, if too tight, if you could do a metric caliper reading before, sand to fit, then a reading after. I can fine tune this. I've attached the print file with both dominos on it. Once it's properly fit, I'll create the other lengths.
I do think these are a little too thick. They are showing over the nominal sizes. I modeled mine slightly under and they were still a little too tight on first iteration. I have also added "pull holes" to make them easier to remove with a driver bit, etc.
