Guys used my mates 420 today he's had it for a couple of months but hasn't used it much. We didn't take much kit to site and ended up clamping a level to use as a straight edge the blade ended up trashed wtop undercut. Tried again same result then checked underneath the guide block with the torx screw was no where near central adjusted it and cut a lot better.
We had adjusted the blade guide before cutting.
Even though it cut better it still seemed like we were cutting out of line with the base and blade.
Any tips on adjusting it for good set up
We had adjusted the blade guide before cutting.
Even though it cut better it still seemed like we were cutting out of line with the base and blade.
Any tips on adjusting it for good set up