can you help ID this part?

[evanism]

Hi all,

I've unpacked my gear after moving interstate (after it sitting for 10 months). I have a spanky new work area with lots of room  [laughing], so I pulled everything out, cleaned it all up and admired it all new again.

Found a part I have absolutely no memory of, or how to use.  Checked my router, circular saw, biscuiter, table, etc, etc and cant even find a palce it fits let alone any possible use for it!  [eek]

Can anyone help?

Ev

 

[mouppe]

Bingo. It's part of the CMS router module OF that you use with curved or template pieces. It stops you pushing the wood too far into the bit.

Richard.

 

[Kev]

Another Ozzie. YEH!

[welcome]

 

[evanism]

How does one use it?  I have looked at every nook, cranny, hole, wind-in and slide and it fits not a thing!

Anyone have a picture of how its used?

 

[mouppe]

Fast forward to 4.10 in to see the bit being set up.

Setting up the Festool CMS router module for curved work