CMS 14' long router table

Joined
Oct 25, 2013
Messages
431
Crown stops, bolts, plywood and a ladder.

14' long router table, plenty of support for workpieces, assembles in 60 seconds per side and that's set level with the table, cost less than a tenner to add 6' per side. Works just as well with the CMS TS-55R and TS-75 table saw modules. Easily copes with 18'' width on an 8' length.

Not quite as stable as the extensions I made for the MFT/3 but a big improvement on roller stands or the tiny table that comes with the CMS set.
 

Attachments

  • SDC12107.JPG
    SDC12107.JPG
    1.7 MB · Views: 702
Nice job!

I use the Kapex extensions, and they attach fine to the MFT, but they sit high on the CMS. (I have a VL attached to the MFT.)

Anyone else have that issue?

 
The extensions are about as stable as the Kapex UG extension wings only much wider, they also attach a bit easier using a crown stop rather than the small clip on the UG wing.

Easy to move around workshop as the extensions attach in a minute and can be removed in half of that. I can even leave the OF2200 in the CMS stand and fold the legs for transport making a 14' long router table very portable.

 

Attachments

  • SDC12100.JPG
    SDC12100.JPG
    1.7 MB · Views: 394
Back
Top