W Woodsgood Member Joined Dec 1, 2011 Messages 50 Dec 14, 2013 #1 Hi, I believe that the in feed fence on my CMS cannot be set coplanar to the out feed side. I've set the adjuster on the, in feed fence, as far out as it goes and the straightedge shows about a 1mm + setback. Does this sound right? Thanks
Hi, I believe that the in feed fence on my CMS cannot be set coplanar to the out feed side. I've set the adjuster on the, in feed fence, as far out as it goes and the straightedge shows about a 1mm + setback. Does this sound right? Thanks
tbellemare Honorary Member Member Joined Nov 3, 2007 Messages 5,133 Dec 14, 2013 #2 Did you make all of the adjustments on this page? Tom
W Woodsgood Member Joined Dec 1, 2011 Messages 50 Dec 14, 2013 #3 Tom Bellemare said: Did you make all of the adjustments on this page? Tom Click to expand... Not the last two steps. Thanks I think that should do it.
Tom Bellemare said: Did you make all of the adjustments on this page? Tom Click to expand... Not the last two steps. Thanks I think that should do it.
