Hello everybody 
Is the eccentric roller and eccentric bearing functioning correct on this Sliding Table?
Please, see the video below. Both eccentric rollers (Att:50) makes a little ‘click’ wobble. I’m not sure if this is normal or not?
The rear left eccentric bearing (Att:44) is loose, the other one is not? View attachment 2
I can adjust the bearings , so rollers don’t click, but then its almost impossible to slide the table [huh]
[attachimg=1]
Any ideas, suggestions, would be highly appreciated!
Is the eccentric roller and eccentric bearing functioning correct on this Sliding Table?
Please, see the video below. Both eccentric rollers (Att:50) makes a little ‘click’ wobble. I’m not sure if this is normal or not?
The rear left eccentric bearing (Att:44) is loose, the other one is not? View attachment 2
I can adjust the bearings , so rollers don’t click, but then its almost impossible to slide the table [huh]
[attachimg=1]
Any ideas, suggestions, would be highly appreciated!
