CSC SYS 50 alignement sliding table

[Xere]

Hi Guys,
I am reading you for long time although I am based in France I love your forum and the quality of the exchange.

Therefore I decided to contribute with a question I have regarding my last acquisition the cordless table saw CSC SYS50

First of all I want to tell you that I was impressed about this tool, this is for me clearly SciFi tool as it is fantastically made.

I start play with it and really enjoy.

The only point I notice is regarding the angle calibration of the blade. I have been following the manual and calibrate with square at the right of the blade and fine. Then I start checking with the square placed on the sliding table and discover a small difference. I then check alignement between table and sliding table and sounds like they are not perfectly aligned.

I was wondering if any of you know if it is normal or how I can adjust this to get perfect alignement between blade, table and sliding table.

Hope you will be able to support.

Thanks guys





https://ibb.co/WcBMqsrhttps://ibb.co/BZ8kprLhttps://ibb.co/QDrF8qQhttps://ibb.co/6ByCHN9

 

[Xere]

Additional content

 

[woodferret]

One of your pics has daylight underneath the sliding table.  Is it not flat or is table lower than the fixed bed?

 

[Xere]

Thanks for your comment, I checked and this is not the case, I intently took this picture showing the angle left right of the sliding table. Maybe not the best way to show this issue

One of your pics has daylight underneath the sliding table.  Is it not flat or is table lower than the fixed bed?

 

[ElectricFeet]

[member=80651]Xere[/member] Just to be clear for anyone who comes across this thread: you’ve now fixed this with [member=72072]woodferret[/member] ’s help in this other thread, right?https://www.festoolownersgroup.com/festool-tools-accessories/festool-csc-sys-50-tablesaw/

 

[Xere]

Yes I confirm that we found a fix for the angle of the table  and again i am plenty satisfied of this wonderful table saw.

[member=80651]Xere[/member] Just to be clear for anyone who comes across this thread: you’ve now fixed this with [member=72072]woodferret[/member] ’s help in this other thread, right?https://www.festoolownersgroup.com/festool-tools-accessories/festool-csc-sys-50-tablesaw/