Csc sys 50 table saw

[chayu]

Hello has anyone had the error message that it cannot complete the calibrations cycle ? (the one you need to hold the large green button down to complete)

My saw got out of whack apparently
Stopped working and said it needed to perform this and then said that it,could not and won’t run anymore.

I,need to get back to work!  Help!!

 

[guybo]

Hi, did you try the reset to factory setting?

 

[chayu]

How do you do that?

 

[chayu]

I’m not able to get into that menu…..it’s stuck on the error message

 

[guybo]

Hi, even if you cycle the power that screen still stays up?

 

[chayu]

Yes

 

[guybo]

Hi, I test drove one ,it was not for me, however the battery in slot#2 ran down more quickly than slot1 stopping the saw .I swapped batterys and it restarted,I did have to reset angle and height.Sorry this is of little help.It seemed this rebooted the saw.

 

[woodferret]

Did you clean out the bottom of the saw?  It gets substantial build up that can sometimes block the motor from hitting the required limit switches used during calibration.

 

[chayu]

Thank you I will,clean it thoroughly and retry

 

[MJT888]

Hi

Did you resolve this?  I’m having the same issue.