CT 26 hook up to Bosch Glide 12inch Saw

[Rob in Vancouver]

Anyone done this,  what works best?
Use Bosch adapter??

 

[G3Trim]

The standard 27mm hose just plugs into dust shoot, but I found the volume of air flow wasn't that great. I use my 36mm hose with a adapter that happen to come with my Bosch 572 jig saw. The number for the adapter is the vac024 on bosch site. I found that it works better. only problem I've had with that set up is all the weight on the 90degree fitting on the saw, it will want to pop out if not really seated well. I hope this helps, if you come up with something better I'm all ears.

 

[bigarm]

Not to hijack this thread, but more to piggy back on it - I have the Bosch 10 inch glide and would like to hook up the 36 mm hose to it.  It doesn't seem to fit on.  Any ideas?

 

[Tinker]

Check out Fernco fittings.

 

[Claimdude]

Not to hijack this thread, but more to piggy back on it - I have the Bosch 10 inch glide and would like to hook up the 36 mm hose to it.  It doesn't seem to fit on.  Any ideas?

I used a Bosch 35mm non-antistatic hose on my Bosch 10" glider. Got the hose off Amazon for $50 bucks or so.

Jack

 

[Peter_C]

I use a regular shop vac hose attached to a Dust Deputy, with the other end on my Bosch miter saw. The adapters came from Home Depot and are sold in a pack. Fits over the outside, but it falls off really easy, so I taped it on. Any big box store should have something.
http://www.homedepot.com/p/RIDGID-3-Piece-Adapter-Kit-VT1755/202077239