Hi,
Has anyone set up an MFT that will cut 96" using the actual MFT mechanism?
Seth Semenza
srs
Has anyone set up an MFT that will cut 96" using the actual MFT mechanism?
Seth Semenza
srs
Custom MFT
- Thread starter semenza
- Start date
Corwin said:
Does the long rail droop alot in the center before it is positioned on the work piece?
Seth
Corwin
Member
- Joined
- Jan 22, 2007
- Messages
- 2,624
Here we are talking about a 118" rail. Now, I thought a rail that long would certainly droop too much. But I was wrong! This table configuration is not in place right now so I cannot readily measure, but as I recall you only need to raise the rail a few (several?) inches to get the entire length up off the material. Just hang a string down from the ceiling...
Gotta Go!
Corwin
Gotta Go!
Corwin
bgray43050
Member
- Joined
- Jan 25, 2007
- Messages
- 25
Mine will handle 96".
It will overhang the table, but I have had no problems. I usually have to make layout lines and clamp the one end of the rail, but no big deal. The repeatability is not there because of the overhang, but it doesn't bother me.
http://www.briangray.net/projectdetail.cfm?ProjectID=32
It will overhang the table, but I have had no problems. I usually have to make layout lines and clamp the one end of the rail, but no big deal. The repeatability is not there because of the overhang, but it doesn't bother me.
http://www.briangray.net/projectdetail.cfm?ProjectID=32
