Cutting right angles in sheetgoods with TS55

[calgaryguy]

I'm aware of the MFT/3 table with right angle track for doing perfect right angle cuts in sheetgoods. I'm wondering if there are alternatives available much like the Seneca Incra T-Track are a alternative to the Festool Parallel Guide Set.

TIA!

 

[them700project]

woodpecker should get on this

 

[rmwarren]

I'm aware of the MFT/3 table with right angle track for doing perfect right angle cuts in sheetgoods. I'm wondering if there are alternatives available much like the Seneca Incra T-Track are a alternative to the Festool Parallel Guide Set.

TIA!

[member=55064]calgaryguy[/member] - Is this the type of thing you are thinking of?

http://festoolownersgroup.com/festool-jigs-tool-enhancements/fs-guide-rail-t-square-latest-creation/msg407751/#msg407751

RMW

 

[calgaryguy]

Richard,

Something very much along those lines. I had actually looked at the thread with the prototype T-Square just before creating this thread.

CG

[member=55064]calgaryguy[/member] - Is this the type of thing you are thinking of?

http://festoolownersgroup.com/festool-jigs-tool-enhancements/fs-guide-rail-t-square-latest-creation/msg407751/#msg407751

RMW

 

[Jonnio]

Hi there, is this the type of thing that may be useful??
https://www.festool.co.uk/Products/Accessories/Pages/Detail.aspx?pid=768168&name=Accessories-for-guide-rails-FS-AG-2