Domino.. stuck guide pin?

[Canucker]

I am in the middle of a project which requires a bunch more domino's ..

Just noticed the guide pin is stuck in on the right hand side..

I pressed it with a small screwdriver.. thinking it would pop back out.. it just stayed in further.

That is a small pic..

I am tempted to undo the set screw and remove it.. I need it working .. now..

Anyone had this problem before?

 

[Les]

No I haven't had this problem but I had to adjust the eccentric bushing as shown on page 21 of this manual. After you loosen or remove the set screw, you can drive out the bushing and pin. This should allow you to fix any problem. Make sure you mark the radial location of the eccentric bushing before dis-assembly.

 

[Brice Burrell]

There is a very simple solution, check out Jerry Work's post here.