I 3D printed a design to hold my set of 140mm Drillpro clamping squares I got from Banggood.
Gauging interest if some of you that have similar sets of clamping squares (bigger/smaller should work too) would be interested in purchasing a set to DIY a rack with whatever surface you would screw these to. If so, could get these up in my Etsy page.
Let me know what you think!
[attachimg=1]
[attachimg=2]
[attachimg=3]
Gauging interest if some of you that have similar sets of clamping squares (bigger/smaller should work too) would be interested in purchasing a set to DIY a rack with whatever surface you would screw these to. If so, could get these up in my Etsy page.
Let me know what you think!
[attachimg=1]
[attachimg=2]
[attachimg=3]
