Fast Fix Drill Guide Chuck

[semenza]

Hi,

        How about a Fast Fix chuck that is a drill guide?  Basically a plunge mechanism on rods attached to the front of the drill (C12). To allow for controlled plunge drilling to a set depth.   To keep the drill perpendicular when added accuracy is needed. Or to allow accurate drilling of angled holes.

Seth

srs

 

[Qwas]

I'm not sure I'm following your thought but maybe something like an OF-1010 router base with the plunge mechanism still intact?

Sort of like the router motor is replaced by the C12 strapped into place.

 

[Qwas]

Oh, I just seen your other post. I wasn't far off.

I'm not going to post the picture here.  Maybe someone else comes up with a better idea...