Festool CMS VL and the MW1000 table

[tut789]

HI. I sold my two MFT tables awhile back, and I am looking for away to continue using my CMS VL (two legged version) and wondered if i could use the MW1000 table.

Other suggestions are also welcome.

Thanks. 

 

[Cheese]

Why not just gin something up using 80/20.

 

[tut789]

Because time my friend is in short supply..

What's the bike in your avatar? BMW?

 

[woodferret]

HI. I sold my two MFT tables awhile back, and I am looking for away to continue using my CMS VL (two legged version) and wondered if i could use the MW1000 table.

Other suggestions are also welcome.

Thanks.

Here's using the CS50 extension table, which is 'almost' the same as the VL - just shorter.

 

[Cheese]

Because time my friend is in short supply..

What's the bike in your avatar? BMW?

750 Norton Commando ...short stroke...still own it but it needs some love.  [smile] 

 

[cpw]

HI. I sold my two MFT tables awhile back, and I am looking for away to continue using my CMS VL (two legged version) and wondered if i could use the MW1000 table.

Other suggestions are also welcome.

Thanks.

I don't have the CMS, but the MW1000 table does lock into the MFT3 extrusions or the cart; and has the same extrusion on the side; so anything that locks into the same extrusions should also lock into your MW1000 table.