Thank you for the replies guys.I have to say I did see the Powertool-supplies.co.uk listing but it seemed too cheap for such a part (knowing how expensive Festool normally are) so I thought that could not be the item I was looking for. Thanks again.
Festool Guide Bushing Adaptor issue
- Thread starter gotallie
- Start date
GarryMartin
Member
- Joined
- Jun 11, 2011
- Messages
- 1,975
Woodmatt said:
If it makes you feel any better, it was £10.99 when I bought it, but it has been lower than £1.61 too [wink]
http://festoolownersgroup.com/festool-tools-accessories/of-1010-and-guide-bushes/msg297635/#msg297635
radujiscanu
Member
- Joined
- Nov 30, 2022
- Messages
- 1
For the OF 2200 i buy guide bush adapter 494627. What guide bushes set fits? Any recommandation îs wellcome
Crazyraceguy
Member
- Joined
- Oct 16, 2015
- Messages
- 4,905
I have both the OF 1010 and OF1400 and never had a bushing fit problem with either, using several different brands. I have run into thread differences, where the "nuts" were not cross-compatible, but they all fit in the opening.
Kreg is the one who let me down recently. I have had the bushing adapter that goes in my router table plate for a few years, as part of a kit, never used. The one time it would have been handy...it wouldn't work. The main OD of the bushing if just too large. The threaded portion goes through the smaller bore just fine.
Kreg is the one who let me down recently. I have had the bushing adapter that goes in my router table plate for a few years, as part of a kit, never used. The one time it would have been handy...it wouldn't work. The main OD of the bushing if just too large. The threaded portion goes through the smaller bore just fine.
Similar threads
