Help with Domino for panels

[ocd]

Hi again,
I have often said my tools wish they had an owner who could use them properly.

It occured to me that I could use my Domino (the smaller one) to help with some 1/2-3/4" panels for a blanket chest.  Since this didn't occur to me before, now I have to go back and use the Rotex 125 Sander to smooth over the joint lines in most of the panels already built (see prior post).

So-I appreciate any advice on using the Domino to help keep the panel components flush.  We are talking mahogany, milled to 3/4", 5-7 boards about 44" long.

Thank You!  David

 

[truck90278]

using the 500 is great for this purpose.  I would suggest 3-4 dominos (5mm dominos) across the length.  Start with a tight fit at one end for alignment purposes then run the remainders on the loose fit position.  If you hold the domino firmly and push gently from the cord end, alignment should put you in good shape.