Icestation2
Member
- Joined
- Jun 24, 2009
- Messages
- 13
I need to cut 30mm thickness sheets of MDF into 17mm wide strips - each sheet being 1250mm wide. I?m considering buying the Festool TS55 system but I?m unsure how easy and fast it is to reposition the guide. I like the idea of using something like the Festool system because it is important that each strip is cut accurately and has perfect 90 degree sides.
I?m really looking for a set-up where the guide is kept exactly square and you just slide the guide to the next mark. I have tried using a basic circular saw guide clamp but you have to mark the top surface twice on every cut so that the clamp is square. I notice that Festool also make a Multifunction Table but once again I need some idea as to how fast it is to reposition the guide because I need to be able to cut strips as fast and accurately as possible.
Also, can anyone tell me if it?s possible to use a 1.5mm thickness circular saw blade in either the Festool TS55 or TS75?
I?m really looking for a set-up where the guide is kept exactly square and you just slide the guide to the next mark. I have tried using a basic circular saw guide clamp but you have to mark the top surface twice on every cut so that the clamp is square. I notice that Festool also make a Multifunction Table but once again I need some idea as to how fast it is to reposition the guide because I need to be able to cut strips as fast and accurately as possible.
Also, can anyone tell me if it?s possible to use a 1.5mm thickness circular saw blade in either the Festool TS55 or TS75?