I needed a workstation for my T-7. I wanted a height of 77-80 cm, wheels, a tray to take up spillage (from jointer blades and so on) and I need it to disappear when I dont use it. The systainers solved the problem. You need two sys-4, one sys-roll and a not too tall plastic tray about the same size as the sys-roll. I timed it, 18 seconds to assemble ;D



This would work, but better to do it properly and make a base plate. I used 10mm plywood shaped to the bottom of the tray with pegs for the systainer. This means every part sits tight in use but is not fastened. The writing is just to remind me which side should face forward to fit the systainer tightly. My Tormek is not here at the moment, but I know the height of 78-79 cm (bottom of tray) is perfect.







This would work, but better to do it properly and make a base plate. I used 10mm plywood shaped to the bottom of the tray with pegs for the systainer. This means every part sits tight in use but is not fastened. The writing is just to remind me which side should face forward to fit the systainer tightly. My Tormek is not here at the moment, but I know the height of 78-79 cm (bottom of tray) is perfect.



